下面小编跟大家一起来分享下导热油加热器在使用过程中，出现反常时跟怎样处理：

反常1：当循环泵的电流比正常值低时，电加热器致使循环泵的效率和流量降低。

　　缘由：有可能是供热管线积垢堵塞形成的。

　　处置：清洁消堵。

　　反常2：循环泵压不改动，电流升高而流量却降低。

　　缘由：有可能是热传导液变质，粘度添加形成的。

　　处置：及时替换或再生导热油，一起注意排气。

　　反常3：循环泵电流值减小，出口泵压回零，阐明泵空转不供油。

　　缘由：可能是导热油汽化所形成的，查明汽化缘由采纳相应的措施。

　　处置：如果因过滤器堵塞而使循环泵抽空，应当即开旁通清洁过滤器；如果因新添加的热传导液含水或水分化的气体在体系内未扫除，则应当即翻开放空阀排气。

　　反常4：液相热载体炉出口温度低，供热量缺乏，而排烟的温度超越300℃。

　　缘由：引风缺乏使燃烧强度不行，形成排烟温度低。

　　处置：及时吹灰。着重查看炉后部出渣机水封、除尘器出灰口等处是不是封闭好，有无凉风很多漏入。

　　反常5：过滤器前后压差添加，泵进口压力降低时，

　　缘由：可能是滤网堵塞。

　　处置：注册旁路，将过滤器拆卸清洁。

　　反常6：炉排中止转变。

　　缘由：链条太松，与链轮啮合不好致使，或者是因链轮磨损严峻，与链条连接不良形成的。

　　处置：调整两侧的调整螺丝，将炉排拉紧，若仍不能正常转变，则需要互换链轮。

　　反常7：炉排卡住。

　　缘由：炉排片折断或销子掉落。煤中有金属夹杂物将炉排卡住；炉排片拱起；挡渣器（老鹰铁）顶级下沉，将炉排卡住。

　　处置：用板手倒转炉排铲除杂物，替换开裂炉排片后再发动，如发动后再卡住，则中止转变后，具体查看缘由再处理。

liquid water or gas within the system did not wipe out the differentiation of water, you should open vent valve exhaust.

Abnormal 4: liquid heat carrier furnace outlet temperature is low, the lack of quantity of heat, exhaust smoke temperature above 300 ℃.

Reason: not bring a lack of wind that combustion intensity, exhaust smoke temperature is low.

Disposal: blowing in a timely manner. Rear view emphatically furnace slag machine water seal, filter out the place such as grey cast is closed well, have many leakage into the cool air.

Abnormal 5: filter pressure difference before and after adding, pump inlet pressure to reduce,

Reason: it could be filter clogging.

Disposal: registered bypass, will remove clean filter.

Abnormal 6: grate to suspend the shift.

Reason: the chain is too loose, and sprocket meshing is bad cause, or because of the sprocket wheel wear serious, in connection with the chain of bad form.

Disposal: adjustment on both sides of the screw, will be grate taut, if still cannot normal shift, you need to swap the sprocket.

Abnormal 7: grate stuck.

Reason: the link broken or pin drops. With metal inclusions in coal grate to get stuck in; Link hog; Iron slag (eagle) top sinking, grate to get stuck in.

Disposal: inverted by means of a grate to remove debris, to replace the cracking link again after launch, such as launch and then gets stuck, was suspended after the shift, see exactly why.

本文来自 http://www.jrqxh.com